Swimming pool daily maintenance and precautions! worth collecting
1. Daily maintenance of swimming pool pumps.1. Check frequently and clean the waste basket regularly. When cleaning, do not knock the waste basket. If the waste basket is damaged, it should be replaced in time.
2. Check the sealing ring of the pump head cover regularly. If it is damaged, please replace it in time.
3. Keep the motor clean and keep the motor air outlet unobstructed.
4. Occasionally, the shaft sealing ring of the motor will be worn and should be replaced in time.
5. In winter, the accumulated water in the water pump head should be removed, the inside and outside of the water pump should be cleaned, and the water pump should be stored in a dry and well-ventilated room.
6. In winter, the water level should be discharged below the water suction inlet to prevent freezing of the pool body and filtration circulation system.
2. Common knowledge about swimming pool equipment. Daily testing of pool water quality is indispensable. Once every two hours after opening, it is best to use automatic inspection and control to maintain water quality balance.
3. After adding coagulant to the swimming pool equipment, try to let the circulation system run for half an hour. If flocculent sediment is found in the water, it should be kept still for 6-8 hours, and then the sediment should be discharged with suction equipment. You must be patient when vacuuming.
4. For outdoor swimming pool equipment, in summer, especially during the rainy season, attention should be paid to preventing the occurrence of algae, and algaecide should be added early before thunderstorms come.
5. The most important factor affecting the quality of water in swimming pool equipment is the PH value. The optimal PH value of pool water is 6.5-7.8. If the PH value is wrong, all previous efforts will be in vain!
6. Backwashing of swimming pool sand pool
Turn on the main circuit power of the water pump, turn on the water pump for flushing for 3-5 minutes, and observe whether the water in the fluorescent inspection bottle is clear during the flushing process. After cleaning, turn off the water pump and adjust the valve on the sandbox to the "filter" position.
8. After the swimming pool stops using water in winter, the inner wall of the filtration system and all equipment components should be scrubbed clean. After air drying, place desiccant in the water pump box and close the lid: Check regularly every month whether the inside of the water pump box is dry and clean.
9. After stopping adding medicine or using disinfectant in the swimming pool, the swimming pool water treatment equipment should be cleaned with clean water again to avoid some medicine remaining in the equipment, and there should be no particulate matter after the medicine liquid is mixed and melted to avoid damaging the swimming pool equipment and dosing pump. Cannot idle for a long time. In addition, when no drugs are added, the valve at the outlet of the metering pump should be turned off, and the equipment should be placed in a dry place.
